Filament guides
PETG not sticking to the bed?
If PETG is not sticking to the bed, check that the surface supports PETG, prepare it using the plate maker’s instructions, and verify the first-layer profile and temperatures. If PETG is sticking too well, follow the plate’s release instructions before attempting removal. Both problems need the exact plate type identified first.
Describe the failure before changing settings
Watch a small first-layer test. Note whether the first lines fail to attach, only one area lifts, or the part releases later. Save a photograph and the slicer profile. Keep those observations separate: “not sticking” can describe different failures, and a successful first line does not show how the finished part will release.
Record the surface name, filament series, nozzle size and selected printer profile. A generic label such as “PEI” may miss an important difference between smooth and textured plates.
Work through a first-layer check
- Confirm surface compatibility. Read the plate maker’s PETG guidance, including any required separation layer. Prusa warns that PETG can adhere strongly enough to damage smooth PEI. A clean surface still needs the correct preparation for this material.
- Prepare the plate as instructed. Use its approved cleaning method and avoid touching the prepared print area. Cleaning products, coatings and release methods are surface-specific; do not assume that a solvent or glue recommended for another plate is suitable.
- Check first-layer calibration. Follow your printer’s levelling or calibration procedure. Excessively lowering the nozzle can damage the surface. Keep a record of adjustments and stop a test if the nozzle is scraping or the layer is clearly failing.
- Verify the material settings. Check nozzle and bed temperatures against the current filament label, the plate limits and the printer profile. Review the first-layer speed using the printer maker’s guidance. Change one setting before repeating the same small test.
Prusa’s first-layer guide explains surface preparation, calibration and its smooth-PEI warning. Use its model-specific adjustments only with the applicable equipment.
Match the bed temperature to the series
The PETG temperature table lists the verified supplier references for our range. Bambu Lab PETG Basic’s PEI reference, greatsimple PETG HF and Tinmorry PETG-ECO have different bed guidance. The verified R3D Off-White and Transparent 3kg label information gives a nozzle range; it does not establish a bed temperature. Check that roll’s current instructions.
Common questions
What if PETG is sticking too well?
Allow the plate to reach the removal condition specified by its maker and follow its release procedure. Avoid forcing the part off. If it will not release as instructed, ask the plate manufacturer for advice before using tools or chemicals. Check the preparation required before the next PETG print.
Should I keep increasing bed temperature?
Stay within the filament, surface and printer limits. Check the observations from your test first. Use the same model and compare one supported change, rather than changing temperature, calibration and speed together.
Could damp filament be involved?
Check filament condition if extrusion is also inconsistent. Popping or bubbles warrant investigation alongside your settings. Our PETG drying guide explains the available series references without treating those symptoms as proof of moisture.
For your next project, compare Bambu Lab PETG Basic refills or the current filament range. Check the product’s setup information and spool requirements alongside your printer and plate.