ESP32-S3 N16R8 Getting Started Guide for NZ Makers
Set up an ESP32-S3 N16R8 board in Arduino IDE: the settings for 16 MB flash and 8 MB PSRAM, a first test sketch, and the pins to leave alone.
Read articleESP32-S3 builds, printed PETG enclosures, AI-assisted firmware and filament advice for New Zealand makers.
Set up an ESP32-S3 N16R8 board in Arduino IDE: the settings for 16 MB flash and 8 MB PSRAM, a first test sketch, and the pins to leave alone.
Read articleA repeatable way to build ESP32-S3 firmware with an AI coding agent: command-line builds, a hardware notes file, timed serial capture and sensible guardrails.
Read articleMeasure your ESP32-S3 board, describe the case to an AI coding agent, and print a parametric PETG enclosure with OpenSCAD. Includes a working example file.
Read articleBuild a Wi-Fi humidity monitor for a filament dry box with an ESP32-S3 and an SHT31 sensor. Includes wiring, a complete sketch and a printed PETG sensor pod.
Read articleMeasure your ESP32-S3's Wi-Fi signal, place the board well inside a printed PETG case, and decide when an external FPC antenna is worth fitting.
Read articleSeven practical ESP32-S3 projects for New Zealand conditions, from a rainwater tank monitor to a frost alert, each with parts to buy and PETG parts to print.
Read articleLooking for PETG filament in Auckland? Compare local suppliers, 1kg refills, 3kg rolls, pickup and NZ delivery options before you buy.
Read articleWhy choose PETG over PLA? Discover why we prefer PETG for practical 3D printing projects in Auckland's coastal climate, based on our own printing experience.
Read articleCompare PETG and PLA for stiffness, impact, heat and printing behaviour. Choose for your actual part, then check the filament and printer requirements.
Read article